Agricultural drones consume fast power, fear that the charging method is wrong.
After the plant protection drone is finished, don't forget to charge it, because if the battery is low, the drone will not be able to continue the operation. Recently, some users have responded to us, and the plant protection drone consumes more and more power. In fact, everyone should know that the wrong charging method will also speed up the power consumption of the drone. The following is a misunderstanding that is easy to make when charging the plant protection drone. Let's see if you have committed it.
Plant protection drones consume fast power, fear that the charging method is wrong
First, the battery is not put
The plant protection drone battery voltage drops too fast, poor control leads to over-discharge, light damage the battery, and the voltage is too low to cause the bomber. Some flying hands have a battery because they have fewer batteries, so the battery is short-lived. As everyone knows, this actually increases the cost of use. The corresponding strategy is to fly as little as possible for one minute, and the life span will fly one more cycle. Would rather buy two more batteries, and don't fly the battery beyond the capacity limit every time. Therefore, you must use the battery in strict accordance with the flight requirements. When the plant protection drone has a low battery alarm, it should land as soon as possible.
Second, the battery is not charged
Some plant protection drone chargers are not fully functional after being fully charged, resulting in a single battery that has not been charged until 4.2V is fully charged. In addition, some chargers are prone to overfill after a period of use. The problem of stopping, and if the lithium battery is overcharged, it will affect the battery life, but the explosion will directly appear. Therefore, to prevent overcharging of lithium batteries, the following points should be noted:
1. Use a dedicated plant protection drone charger. This charger can be a dedicated charger for lithium ion or lithium polymerization, which is very close. Some mobile phone chargers can be used to charge lithium polymer batteries, which will not damage the battery.
2. Set the number of battery cells in the battery pack accurately. In the first few minutes of charging, you must carefully observe the display of the plant protection drone charger, which will display the number of batteries in the battery pack. If you are not sure, you should not charge or use a charger that you are familiar with.
Third, not full of electricity to save
Fully charged batteries are extremely chemically active, so they cannot be fully charged for more than 3 days. If they are not discharged for more than one week, there is a risk of flatulence. Some batteries may not be drummed for a while, but after several times of full power storage, the battery may Direct scrapping.